50 – English
5.5 Cooling system
5.5.1 Changing the oil cooler
Dismantling
Tools Dimension
Combination wrench 10 mm
Combination wrench 19 mm
1. Open the engine cover.
2. Loosen the electrical connector.
3. Mark the hydraulic hoses so that they are
reconnected correctly.
4. Clean thoroughly as instructed. For further
instructions, refer to section “5.6.1 Hydraulic
hygiene” on page 52.
5. Loosen the hydraulic hoses. Fit sealing plugs to
prevent leakage and contamination.
7. Lift away the oil cooler.
Assembling
Assemble in reverse order.
6. Remove the screws, two on each side of the
cooler.
Cooling system
To Next Page
Loading...
