Husqvarna P524 - Ignition Switch; Hour Meter

46 – English
5.3.7 Ignition switch
Tools Dimension
Combination wrench 18 mm / 19 mm??
Torx T30
Wrench
Dismantling
1. Remove the side cover.
2. Loosen the ignition switch connection from the
circuit board.
3. Remove the ignition key.
4. Dismantle the washer and nut under the ignition
key.
5. Release the ignition switch by pushing it down
through the panel.
Assembling
Assemble in reverse order.
5.3.8 Hour meter
Dismantling
1. Remove the front cover, steering column.
2. Release the cables from the hour meter.
3. Loosen the hour meter by compressing the
bracket and pressing it out through the steering
wheel console.
Assembling
Assemble in reverse order.
NB!
Make sure the connector goes into the right
position (click lock).
Tools Dimension
Torx T30
Electrical system