Husqvarna P524 - Checking Tyre Pressure; Checking Cooling Air Intake; Replacing the Cutting Belt

24 – English
Chassis
5.1.6 Changing joint bearing in articulated unit
1
2
3
4
1. Control stay
2. Joint bearing in
articulated unit
3. Steering cylinder
4. Link stay
Tools Dimension
Combination wrench 13 mm
Combination wrench 15 mm
Combination wrench 16 mm
Combination wrench 22 mm
Combination wrench 27 mm
Combination wrench 32 mm
Combination wrench 15 mm
Combination wrench 17 mm
Combination wrench 19 mm
Circlip pliers SGH
Chisel
Torque wrench
Fine threaded torque
wrench
17 mm
WARNING!
Never insert hands or ngers as
heavy components are unstably
supported. Use tools that reach.
Risk of crush injuries.
Check of joint bearing in
articulated unit
Check the condition of the joint bearing in the
articulated unit by measuring the distance between
the joint bearing and the bolt fastener.
1. Make sure there is a clear gap between the link
stay and the screw head on the engine belt
pulley.
If the distance between the pulley and the screw
head reduces, the joint bearing must be changed.