Husqvarna P524 - Cleaning Engine and Muffler; Checking the Safety System; Replacing Light Bulbs; Main Fuse and Power Outlet Fuse

English – 23
14. Release pump belt tension by:
a
b
c
a. Loosen the 3 screws on the pump belt
cradle.
b. Loosen the locking nut on the adjustment
screw.
c. Loosen the pump belt adjustment screw in
order to release tension on the belt.
15. Dismantle the 2 screws holding the bracket for
the pump belt pulley.
16. The screw (2) on the locking plate (3) that holds
the front part of the link stay in place is
dismantled through the seat well.
17. Remove the screw (4) from the link stay and
loosen the front link stay fastening.
18. Dismantle the link stay.
Assembling
1. Assemble in the reverse order. The front link
stay grease nipple must point to the right.
2. Torque tighten as below.
a. The rear screw for the link stay is screwed
into the goods. In addition, there is a locknut
for securing the screw. If the locknut is
tightened too much, the torque on the screw
will be released and the union will come
loose.
b. Tighten the screw (3) until it bottoms rst.
c. Then tighten the screw to the torque
specied in the table.
d.1 Finally, screw on the locking nut (4) and
tighten to the torque specied in the table.
3. Lubricate the link stay through the grease
nipples.
Location Screw Nut
A Front link stay 52 ft/lb (65 Nm) -
B Rear link stay 52 ft/lb (47 Nm) 52 ft/lb (24 Nm)
1
2
3
4
1. Link stay
2. Sleeve
3. Screw
4. Locknut
5. Washer
6. Steering block
4
6
7
3
1
5
2
1. Link stay
2. Screw
3. Locking plate
4. Screw
Chassis