Husqvarna P524 - Replacing Pump Belt

English – 69
5.6.10 Replacing pump belt
The condition of the belt pulleys should be checked
when changing belts in the machine. Replace belt
pulleys if necessary.
1. Fold forward the driver seat.
2. Remove the protector plate located under the
seat.
3. Release pump belt tension.
a
b
c
a. Loosen the 3 screws on the pump belt cradle.
b. Loosen the locking nut on the adjustment
screw.
c. Loosen the adjustment screw for the pump
belt to max.
4. Dismantle the belt pulley for the pump belt on
the left-side of the machine.
5. Dismantle the protective plate over the rear
transmission.
6. Unplug the electrical connector
7. Dismantle the torque stop for the clutch.
8. Remove the front cover to access the PTO belt.
9. Release the belt tensioner.
10. Remove the protecting cover under the engine
pulley.
11. Prise off the PTO belt from the drive wheel on
the cutting deck.
Tools Dimension
Combination wrench 13 mm
Combination wrench 15 mm
Combination wrench 17 mm
Torx T30
Hydraulic system