English – 5
2 Delivery and service
2.1 Service schedule
Key
The following is a list of maintenance procedures that must be performed on the ride-on mower. Most points
not described in this workshop manual can be found in the operator’s manual.
Not described in this workshop manual or operator's manual.
n Described in this workshop manual.
m Described in the operator’s manual.
Care Chapter Daily
mainte-
nance
before
Daily
mainte-
nance
after
After
the
rst 25
hours
Weekly
1)
mainte-
nance
At
least
once
a year
Maintenance
interval in hours
40 100 200 400
Clean under the cutting deck
Clean and lubricate the belt
tensioner bearings.
Clean around the mufer
Clean thoroughly around the engine
Clean thoroughly around the
transmission
m
Clean the frame tunnel
Clean the air lter
m m m
Clean the cooling ns on the engine
and hydrostatic transmission
Clean the combustion chamber
Check the engine cooling air intake
m
Check the fuel pump’s air lter
Check/adjust the parking brake 5.1.3
n
Check the safety system 5.3.5
n
Check nuts and bolts
Check for fuel and oil leakages
Check the oil level in the
transmission and top up if
necessary (SAE 10W/50)
2.2
n
Check the cutting deck bolts for the
belt pulleys, blades, etc.
Check that the hydraulic hoses and
couplings are clean and undam-
aged.
Check/adjust front and rear wheel
rotation speed
5.2.10
n n n n
Check the engine's maximum
speed (3,0000rpm).
3.1
n
Check the air pressure in the tires
100 kPa / 1.0 bar / 14.5 PSI
m m m
Check the fuel hose. Replace if
necessary.
Check that the pump belt tension
is correct
Check that the RTO belt tension is
correct
Delivery and service
To Next Page
Loading...
