Husqvarna P524 - What Is What?; Location of Controls

6 – English
Care Chap-
ter
Daily
mainte-
nance
before
Daily
mainte-
nance
after
After
the rst
25
hours
Weekly
1)
mainte-
nance
At
least
once a
year
Maintenance
interval in hours
40 100 200 400
Check the V-belts 5.7.3
n n
Check joint bearing in articulated
unit
5.1.6
n
Check/adjust the cutting height
setting
5.7.4
n
Check/adjust the choke wire 5.1.1
n
Check/adjust the throttle cable 5.1.1
n
Check that the spark plug is clean
and properly gapped.
m
Check the condition of all pulleys
on the machine.
Check joint bearing wear in articu-
lated unit
Lubricate according to the lubrica-
tion chart
7.5
n n n
Lubricate the articulated bearing 5.1.6
n n
Lubricate the driver seat
Lubricate all cables
Lubricate links in the cutting deck
Lubricate the hydrostatic cable with
linkage
Lubricate the parking brake cable
Lubricate the throttle
Lubricate the choke control
Change oil in the transmission 5.2.4
n n
Change hydraulic oil (SAE
10W/50)
5.2.5
n
Change the engine’s oil lter 5.2.6
n n
Replace the suction lter in the
hydraulic tank
Change hydraulic lter 5.6.5
n n
Change engine oil (SAE 10W/40) 5.2.7
n n n
Change the fuel lter 5.4.2
n n n
Change spark plug
m m
Change air lter 5.2.8
n n n
Replace the cutters in the cutting
deck
m
Replace the pump belt 5.6.13
n
Replace the cutting deck drive belt 5.7.3
n
Replace the cutting deck blade
belts
5.7.3
n
WARNING! Service procedures must not be conducted on the engine or cutting deck unless:
• The engine has been stopped.
• The parking brake is engaged.
• The ignition key has been removed.
Delivery and service
1)
The ride-on mower should be lubricated twice a week when used on a daily basis.