Husqvarna P524 - Checking the Blades; Replacing the Blades; Removing the BioClip Plug; Hydraulic System Oil Level Check

English – 29
5.2 Propulsion
Propulsion
5.2.1 Dismantling the engine cover
1. Remove the screws on both sides of the engine
cover.
2. Save the plastic washers used as spacers
between the screw and the cover.
3. Lift off the engine cover.
Assembling
Assemble in reverse order.
Tighten the screws sufciently so the cover can be
closed smoothly and not fall down of its own weight.
Tools Dimension
Combination wrench
17 mm x2