Husqvarna P524 - All Lubrication Points; General Lubrication Notes

English – 33
Propulsion
5.2.3 Solenoid clutch
Dismantling
1. Dismantle the engine, see section “5.2.2
Engine” on page 30.
2. Counterhold underneath the magnetic clutch
with a wrench.
2
7
8
5
3
1
4
6
3. Loosen the screw (8) holding the belt pulley (2)
and torque disc (6) in place.
4. Remove the belt pulley (2).
5. Replace the magnetic clutch (4) together with
torque disc (6).
Tools Dimension
Wrench x2
Ratchet wrench 16 mm
Assembling
1. Assemble in reverse order.
2. Place the belt pulley key in the groove on the
engine shaft.
3. Put the magnetic clutch on the engine shaft.
There is a key on the engine shaft that must be
located in the recess on the magnetic clutch.
4. Tighten the screw to 75 Nm.