56 – English
5.6.5 Hydraulic tank
Dismantling
1. Remove the side cover.
2. Dismantle the right wing cover.
Tools Dimension
Torx T30
Combination wrench 10 mm
Combination wrench 13 mm
Combination wrench 14 mm
Combination wrench 27 mm
Combination wrench 32 mm
3. Remove the protecting cover protecting the right
side of the machine.
4. Place a vessel underneath the hydraulic tank
drain plug.
5. Drain the oil from the hydraulic tank.
6. The hydraulic hoses can be mixed up. Mark the
lines so that they are reconnected on the correct
connections.
7. Clean according to the general instructions, see
section “5.6.1 Hydraulic hygiene” on page 52.
8. Loosen the upper hydraulic hose. Fit sealing
plugs to prevent leakage and contamination.
9. Loosen the tank with two screws.
Hydraulic system
To Next Page
Loading...
