English – 91
7.3 Troubleshooting schedule
Measure voltage:
Use a multimeter in voltage mode. Hold the red
measuring probe against the measurement point
and the black measuring probe against a grounding
point (e.g. negative battery terminal) and read off the
voltage on the multimeter display.
Measure resistance:
Use a multimeter in resistance mode. Hold the red
measuring probes on the measurement points and
read off the value on the multimeter display.
On contact, the value should be low (<1 Ohm).
On broken contact, the value should be high
(>500 Ohm).
Checking cables and connectors:
When checking cables, look for the following:
• Cable breaks
• Worn cable sheaths
• Cable fastening in terminals
• Cleanliness of terminals
• Tarnished terminals
Appendices and schedules
To Next Page
Loading...
