English – 73
5.6.12 Lift cylinder
Tools Dimension
Combination wrench 19 mm
Circlip pliers SGA
Torx T30
Dismantling
1. Lower the cutting deck.
2. Remove the cover over the frame tunnel.
3. Loosen the lifting chain by pressing the catch.
4. Remove the driver's seat. For further
instructions, refer to section “5.1.2 Driver’s
seat” on page 18.
5. Loosen and plug the hydraulic couplings. For
further instructions, refer to section “5.6.1
Hydraulic hygiene” on page 52.
6. Dismantle the hydraulic couplings at both ends
of the lifting cylinder.
7. Remove the lifting cylinder through the frame
tunnel.
Assembling
1. Assemble in the reverse order.
2. Bleed the lift cylinder by lowering and lifting the
lift arms repeated times with the engine started.
3. Check for any leakage from the lift cylinder
hydraulic connections.
4. Check the hydraulic tank level.
Hydraulic system
To Next Page
Loading...
