76 – English
5.7 Cutting system
Cutting system
Dismantling
1. Remove the cutting deck. For further instruc-
tions, refer to section “5.7.2 Cutting deck” on
page 78.
2. Push down the equipment frame and drop the
catch.
3. Check the measurement of the adjuster screws'
position. Note the values and use them as initial
values when assembling.
?
4. Loosen the adjustment screws.
5. Remove the left wing cover.
6. Remove the automatic belt tensioner stay.
7. Release the lifting chain from the tool frame.
8. Remove the protecting cover on the tool frame.
Tools Dimension
Combination wrench 13 mm
Combination wrench 18 mm
Combination wrench 19 mm
Torx T30
5.7.1 Tool frame
To Next Page
Loading...
