Husqvarna P524 - Starting with a Weak Battery; Connecting Jump Leads; Removing Jump Leads

16 – English
Chassis
5 Repair instructions
Tools Dimension
Combination wrench 10 mm
Torx T30
Snipe nose pliers
Wire cutters
5.1 Chassis
5.1.1 Throttle and choke cables
Checking the throttle cable
Make sure the engine responds to the throttle and
that the correct engine speed is attained at full
throttle. For further information, see “6.1.4 Technical
data - Dimensions” on page 86.
Adjusting the Throttle Cable
If adjustment is needed, do the following on the
bottom cable.
1. Loosen the clamping screw for the cable’s outer
casing and slide the throttle control to the full
throttle position.
2. Make sure the throttle cable is attached to the
correct attaching hole in the lower lever arm.
3. Press the outer sheath of the throttle cable to
the far left and tighten the clamping screw.
Checking the choke cable
Make sure the engine responds to the throttle and
that the correct engine speed is attained at full
throttle. For further information, see “6.1.4 Technical
data - Dimensions” on page 86.
Adjusting the choke cable
If adjustment is needed, do the following on the top
cable.
1. Loosen the clamping screw for the cable’s outer
casing and slide the throttle control to the full
throttle position.
2. Make sure the throttle cable is attached to the
correct attaching hole in the upper lever arm.
3. Press the outer sheath of the throttle cable to the
far left and tighten the clamping screw.