English – 55
5.6.4 Changing hydraulic lter
1. Remove the right side cover.
2. Clean in accordance with “5.6.1 Hydraulic
hygiene” on page 52.
3. Remove the oil lter. If necessary, use a lter
remover.
4. Smear new, clean engine oil onto the seal for the
new lter. Fill the oil lter with new, clean oil.
WARNING!
Used oil lters shall be treated as
environmentally hazardous and
turned in to the workshop or other
designated area for disposal. Avoid
skin contact, wash with soap and
water in case of spills.
5. Fit the oil lter by hand to contact +3/4 turn.
6. Fill the hydraulic tank. Pay attention while
operating and top up the tank so the level does
not get too low.
7. Test drive. Operate the equipment lift and power
steering and then check that there are no leaks
around the oil lter seal.
8. Check the oil level in the hydraulic tank, top up if
necessary. The oil lter capacity is about
0.3 liters/0.3 US qt of oil.
5.6.3 Filter holder
Tools Dimension
Allen Key 8 mm
Combination wrench 17 mm
Combination wrench 22 mm
Combination wrench 27 mm
Combination wrench 32 mm
Combination wrench 13 mm
Combination wrench 22 mm
Combination wrench 27 mm
Torque wrench
Dismantling
1. Remove the hydraulic tank. For further
instructions, refer to section “5.6.5 Hydraulic
tank” on page 56.
2. Loosen the hydraulic hoses and plug the lines
and connections.
3. Mark the location of the hoses.
4. Dismantle the 2 retaining screws (1) holding the
lter holder and remove the holder.
5. If the lter holder is being changed, the
adapters must be removed and reused during
reassembly.
6. Clean thoroughly as instructed. For further
instructions, refer to section “5.6.1 Hydraulic
hygiene” on page 52.
Assembling
Assemble in reverse order.
Hydraulic system
To Next Page
Loading...
