Husqvarna P524 - Lubrication: Hydrostatic Cable; Maintenance: Parking Brake Check; Lubrication: Parking Brake Wire; Lubrication: Throttle Control

English – 19
Tools Dimension
Combination wrench 13 mm
Torx T 30
Snipe nose pliers
Torque wrench
5.1.3 Brake cable
Checking the brake cable
Check that the parking brake is adjusted correctly
by placing the machine on a slope.
• Apply the parking brake.
The parking brake must be adjusted if the machine
is not stationary.
If the machine does not stay still once the parking
brake has been adjusted, the parking brake cable
must be replaced.
Replacing brake cable
1. Remove the cover over the frame tunnel.
2. Remove the left wing cover.
3. Remove the rubber cover from the brake cable.
4. Remove the E-clip.
5. Pull back the rubber protection so that the cable
can pass through the bracket opening.
6. Loosen the recoil spring from the pedal arm.
7. Make a note of how the brake cable is routed.
8. Pull back the rubber protection so that the cable
can pass through the bracket opening.
9. Loosen the recoil spring going to the brake arm.
10. Remove the cable from the brake lever arm.
Assembling
Assemble in reverse order. The parking brake cable
must be checked and possible adjusted once tted.
Chassis