Husqvarna P524 - Bioclip Plug

84 – English
11. Make a note of how the cable is routed.
12. Remove the cable.
Assembling
1. Assemble in reverse order.
2. After assembling, the play in the wire under the
side cover and the cable on the cutting deck
must be checked and adjusted if necessary.
For further information, see “5.7.7 Adjusting the
cutting height range” on page 82.
5.7.9 BioClip plug
To change the Combi Deck from BioClip function to
cutting deck with rear ejection, remove the BioClip
plug fastened under the cutting deck with three
screws.
1. Put the cutting unit in service position, see
“5.7.2 Cutting deck” on page 78.
2. Remove the three screws holding the BioClip
plug. Remove the plug.
Tip: Fit three full-thread screws into the screw holes
to protect the threads when removing the BioClip
plug.
1. Return the cutting deck to the normal position.
2. Fit the BioClip plug in the reverse order.
Cutting system