Husqvarna P524 - Lubrication of Accessories; Lubricating Cables; Cutting Unit Lubrication; Cutting Unit Joints and Bearings

34 – English
Propulsion
Tools Dimension
Torx T30
Allen Key 10 mm
Flat-blade screwdriver
5.2.4 Transmission oil change
Observe cleanliness. Follow the directions in section
“5.6.1 Hydraulic hygiene” on page 52.
Transmission capacity is 0.9 liters (0.9 US qt) fully
synthetic engine oil SAE 10W/50 in the respective
gearbox Make it easier to change oil by warming up
the engine before draining the oil.
Rear axle
1. Place a vessel under the rear transmission.
2. Remove the rear transmission cover.
3. Loosen the bottom plug and allow the oil to drain
into the vessel.
4. Clean thoroughly around the ller.
5. Open the ller cap.
6. Ret the drain plug.
7. Top up with the new oil.
8. There is always a small amount of oil remaining
in the transmission after draining it. Therefore,
always use a dipstick to make sure the oil level is
correct.
Front axle
1. Remove the left wing cover.
2. Place a vessel under the front transmission.
3. Loosen the drain plug and allow the oil to drain
into the vessel.
4. Clean thoroughly around the ller.
5. Open the ller cap.
6. Ret the drain plug.
7. Top up with the new oil.
8. There is always a small amount of oil remaining
in the transmission after draining it. Therefore,
always use a dipstick to make sure the oil level
is correct.
5.2.5 Hydraulic oil change
Hydraulic tank capacity is 8 liters (8.5 US qt) fully
synthetic engine oil SAE 10W/50.
1. Remove the side cover.
2. Dismantle the right wing cover.
3. Remove the protecting cover protecting the right
side of the machine.
4. Place a vessel under the hydraulic tank drain
plug.
5. Loosen the plug and allow the oil to drain into the
vessel.
6. There is always a small amount of oil remaining
in the hydraulic tank after draining it. Therefore,
always use a dipstick to make sure the oil level is
correct.