Husqvarna P524 - Replacing the Engine Oil; Changing the Oil Filter

English – 31
Propulsion
1. Remove the engine cover. For more
information, refer to “5.2.1 Dismantling the
engine cover” on page 29.
2. Remove the battery, see section “5.3.3 Battery”
on page 44.
3. Remove the cable between the starter relay and
the starter from the starter.
4. Mark and remove the engine’s electrical
connectors.
5. Remove the clips holding the throttle and choke
cables. Unhook the cables from their
attachments on the carburettor casing.
Dismantling the motor
NB!
Hold the battery cable screws in place so that
the electrodes are not strained.
6. Remove the hose clamp on the fuel hose by the
fuel pump and pull the fuel hose downwards.
Suspend the hose to stop fuel leaking.
7. Loosen the heat plate over the mufer, two
screws on each side, and remove the plate.
8. Loosen the exhaust clamps at the mufer.
9. Remove the screws from the mufer and lift off
the mufer.