Husqvarna P524 - Hydraulic System

38 – English
4. Loosen the clamp on both ends of the
hydrostatic cable at the frame and the center
console.
5. Lift off the link joint and pull out the cable.
6. Lift out the hydrostatic cable with associated link
joint.
7. Unscrew both link joints from the hydrostatic
cable.
8. Remove the hydrostatic cable.
Dismantling the hydrostatic cable
1. Remove the frame plate by loosening the
screws.
2. Loosen the front hydrostatic cable locking nut
1/4 turn and remove the locking spring.
3. Remove the spring lock and the hydrostatic
transmission cable's rear link joint from the arm
on the hydraulic pump.
Assembling
Assemble the engine in reverse order.
Propulsion