Husqvarna P524 - Page 89

88 – English
Electrical system
Type 12V, negative ground
Battery 12V, 24 Ah
Main fuse, Flat pin, A 20
Elec. socket fuse, Flat pin, A 5
Electrode gap mm/inch 0.75/0.030
Bulbs, halogen 2x12V 20 W
Tightening torques
Belt pulley-cutting deck 35-40 Nm/ 25-28 Ibft
Blades M10 bolt 45-50 Nm/ 32-36 Ibft
Blades M12 bolt 75-80 Nm/ 53-56 Ibft
Blade bearings 20-25 Nm/ 14-18 Ibft
Belt tensioner pulley 15-25 Nm/ 10-18 Ibft
Engine mounting screws 45 Nm/ 32Ibft
Engine pulley 70-80 Nm/ 50-56 Ibft
Control points
Parallelism cutting deck with cutting height in position 1: ± 2 mm/ ± 0.079’’
Control of cutting height in position 1: 40 ± 2 mm/ 1.57 ± 0.079’’
Distance between support plate and drive belt: 3-6 mm/ 1/8’’-1/4’’
Distance belt tensioner lever arm and belt guide,
disengaged deck: 17 ± 5 mm/ 7/16’’ ± 3/16’’
Play
Brake cable: 1 mm/ 0.040’’
Cable hydrostatic pedals: 0 mm
Specications