3-2 MAX200 Instruction Manual
7-99
SETUP
Upon Receipt
The MAX200 power supply is shipped mounted to a skid and protected by a heavy carton cover. Before unpacking
the unit, inspect the carton for evidence of damage during shipment.
1. Remove all packing material and discard and remove the power supply from the shipping skid.
2. Verify that the MAX200 torch standard system configuration items and parts listed below are included. Alert your
distributor if any of the items or parts are missing. All communications regarding this equipment must include the
model number and serial number (located on the back of the MAX200).
MAX200 System – Hand Torch Configuration
• MAX200 power supply
• PAC200T or PAC200E hand torch and torch lead assembly
• 25-foot work cable (ground) with clamp
• Consumable spare parts kit
• Torch coolant – four gallons
• Instruction manual 800870
Damage Claims
If your unit was damaged during shipment, you must file a claim with the carrier. Hypertherm will furnish you with a
copy of the bill of lading upon request. Call Customer Service listed in the front of this manual or your authorized
Hypertherm distributor.
Pre-Installation
Installation and service of the electrical and plumbing systems must conform to national or local electrical
and plumbing codes. Have this work performed only by qualified, licensed personnel.
Power Supply Placement
• Place the power supply in an area that is free of excessive moisture, has proper ventilation, and is relatively
clean.
• Place the power supply so that air flow is not blocked in any way. (Cooling air is drawn in through the front
panel grating, and is exhausted through the rear of the unit by a cooling fan.)
• Do not place any filter device over the air intake locations. This reduces cooling efficiency and VOIDS THE
WARRANTY.
To Next Page
Loading...
Need help?
General
