SlideDriver Installer Checklist
This check list is provided by HySecurity and is to be used after installing a SlideDriver gate operator.
1. Before checking the items in this list, make sure power is turned OFF at the main power
disconnect and the operator’s control box power switch is also in the OFF position.
2. Lower the toggle handle to unclamp the drive wheels from the drive rail and check the
following:
Gate moves smoothly and freely by hand.
Electric motor and transformer wired properly.
Incoming power supply voltage matches the label on the motor.
Gate operator is level.
Operator is labeled as appropriate for both the type and UL usage class of the gate.
Make sure the phase, hertz, and power match the operator and its labeling:
1 Ø 3 Ø 50 Hz 60 Hz
DC-24V 115 VAC 208 VAC 230 VAC 480 VAC ____V
Power cable run to the operator is of sufcient wire size to handle starting current.
NEC/NFPA ground rod is installed.
All wires and cables are clear of moving parts (limits, valves, power, etc.).
Breather cap has been installed, replacing the Vent Plug in the pump.
Oil level checked.
All chassis and base riser bolts are tight.
Gate wheels & rollers have covers.
Pinch points protected.
6 foot (1.8 m) minimum distance to access controls.
Pedestrian gate exists.
Physical gate stops are present.
On gate, protective mesh complies with ASTM F2200 and UL 325 standards.
Gate is not on a slope.
3. For the remaining checks, you want to cycle test the gate operator. To do so,
• Temporarily, disconnect any peripheral devices.
• Re-engage the wheels by lifting the toggle handle and clamping the drive wheels onto the drive rail.
• Turn the main power ON, and then turn ON the power switch located on the operator’s control box.
NOTE: Be sure to read the Installation Instructions and the Programming and Operations Manual that accompany the operator. The
product literature explains, in detail, many aspects about installation, programming, maintenance and safety procedures. If you have
further questions, please contact Technical Support at 800-321-9947.
4. Prior to moving the gate, make sure the wheel clamp spring is compressed to 2 inches (5 cm).
138 MX3630-01 Rev. J SlideDriver/SlideDriver 50VF Series © 2019 www.hysecurity.com
To Next Page
Loading...
Need help?
General
