3-22
i-CAT FLX Installation Manual
032-0330-EN Rev K
• SmartScan STUDIO Manager (required)
• PACS QR - for sites using a PACS for image storage. Can be installed on both the
workstation and the server.
• PACS MWL - for sites using modality worklists for scheduling patients. Can be installed
on both the workstation and the server.
• Legacy Practice Management Viewer Launcher - (for sites using a supported PM
system)
• DEXIS i-CAT FLX Client - (for sites using DEXIS)
b. Click Install.
c. Click Yes on the confirmation dialog. The discovery service prepares for installation. This
may take a few minutes.
4. For SmartScan STUDIO Manager installation:
a. On Welcome screen, click Next.
b. On Select Installation Folder screen, use the default location. Click Next.
c. On Confirm Installation screen, click Next. Installation will start and a progress bar is
displayed.
d. When installation completes, click Close on the Installation Complete screen.
5. If the PACS QR was selected to be installed:
NOTE: For sites using a PACS, additional setup is required. After all software is loaded,
see Configure SmartScan STUDIO PACS Modules (Optional) (page 3-26) for additional
setup instructions.
a. On the SmartScan STUDIO QR Installer window, click Next.
b. On the Ready to Install window, click Install. The software installs and a progress bar is
displayed.
c. When Complete window is displayed, click Finish.
6. If the PACS MWL was selected to be installed:
NOTE: For sites using a PACS, additional setup is required. After all software is loaded,
see Configure SmartScan STUDIO PACS Modules (Optional) (page 3-26) for additional
setup instructions.
a. On the SmartScan STUDIO MWL Installer window, click Next.
b. On the Ready to Install window, click Install. The software installs and a progress bar is
displayed.
c. When Complete window is displayed, click Finish.
7. If the Legacy Practice Management Viewer Launcher was selected to be installed:
a. On Welcome screen, click Next.
b. On Select Installation Folder screen, use the default location. Click Next.
c. On Confirm Installation screen, click Next. Installation will start and a progress bar is
displayed.
d. When installation completes, click Close on the Installation Complete screen.
To Next Page
Loading...
