3-21
Load Clinical Software and Configure System
032-0330-EN Rev K
f. If DEXIS is installed, select next to Practice URL, then select the Practice URL from
the dialog. Enter the Username and Password for the server, then select Test to ensure
the connection is established. Click OK on the pop-up.
g. Click Save & Restart. A message is displayed “Restarting Integration Services. Please
wait (up to 10 minutes).”
NOTE:
• If the PACS Storage Service was loaded, and has not been set up, you will get a PACS
Station error message when closing this window. See Configure SmartScan STUDIO
PACS Modules (Optional) (page 3-26) for additional setup instructions.
• If the Legacy Practice Management Interface was loaded, refer to Configure Legacy
Practice Management Interface (Optional) (page 3-30) for additional setup instructions.
Install SmartScan STUDIO Client Components
SmartScan STUDIO Manager should be loaded on any workstation where the site will be entering
patient exam data or viewing patient images. For sites that use a PACS, load the required SmartScan
STUDIO PACS software on each workstation. For sites that use a supported PM system, load the
Legacy Practice Management Viewer Launcher on all workstations that use it.
1. At clinical workstation, insert media in drive.
2. On AutoPlay pop-up, select Run SssInstallerExecutive.exe. If AutoPlay pop-up does not
display, navigate to the media drive, right-click and select Open AutoPlay.
3. On the SmartScan STUDIO Installer Executive:
a. Select programs to be installed.
To Next Page
Loading...
