Table 1. Service Processor Checkpoints (continued)
Checkpoint Description Action/
Possible Failing FRU
A809 Flash erase start See note 1
A80A Flash erase end See note 1
A80B Reserved; not used See note 1
A80C Reserved; not used See note 1
A80D Reserved; not used See note 1
A80E Reserved; not used See note 1
A80F Service processor dump done See note 1
B00B Firmware delaying to determine if
MOPs error is the result of power
disturbance. After delay, SPCN is
queried for CEC power status.
1. Remove, then reapply power to
the system.
2. Call service support.
B0F5 Delayed power-off sequence has
begun
See note 1
B0FA Delayed power-off acknowledged See note 1
B0FF Power-off requested program
executing
See note 1
Notes:
1. If the system fails to progress after this checkpoint is put in the display, do the
following:
a. Activate the service processor pinhole reset switch on the system’s operator
panel.
b. If the hang repeats, check with service support to see if there is a firmware
update that fixes the problem.
c. If not, or the update does not fix the problem, change the primary I/O backplane.
d. If this procedure does not fix the problem, call service support.
2. If the system fails to progress after this checkpoint is put in the display, do the
following:
a. Activate the service processor pinhole reset switch on the system’s operator
panel.
b. If the hang repeats, check with service support to see if there is a firmware
update that fixes the problem.
c. If not, or the update does not fix the problem, go to “MAP 1540: Minimum
Configuration” on page 113.
d. If this procedure does not fix the problem, call service support.
3. Recovery mode flash update has failed. Do the following:
a. Activate the service processor pinhole reset switch on the system’s operator
panel and try the recovery mode flash update again.
b. If the system hangs again, make a new set of firmware update diskettes, using
new, blank diskettes. Retry the flash update with the new diskettes.
144 Service Guide
To Next Page
Loading...