PCI Hot-Plug Manager Access
The installation instructions for hot-pluggable PCI adapters refer you to these
procedures when it is appropriate to perform them.
Note: A PCI adapter is only hot-pluggable if the PCI adapter is supported for hot-plug
applications. See the
PCI Adapter Placement Reference
, order number
SA38-0538.
Accessing Hot-Plug Management Functions
Note: Removing or installing a Hot-Pluggable PCI adapter requires the system
administrator to take the PCI adapter offline prior to performing the operation.
Before taking an adapter offline, the devices attached to the adapter must be
taken offline as well. This action prevents a service representative or user from
causing an unexpected outage for system users.
For additional information about taking an adapter offline or removing it from the
system configuration, see the
AIX System Management Guide: Operating
System and Devices
. This publication is available at the following Web address:
http://www-1.ibm.com/servers/aix/library/. Select Technical Publications.
This publication is also contained on the AIX Documentation CD. The
documentation is made accessible by loading the documentation CD onto the
hard disk or by mounting the CD in the CD-ROM drive.
To access the hot-plug menus, do the following:
1. Log in as root user.
2. At the command line, type smitty.
3. Select Devices.
4. Select PCI Hot Plug Manager and press Enter.
5. The PCI Hot-Plug Manager menu displays. Return to the procedure that directed
you here. The following section describes the menu options.
PCI Hot-Plug Manager Menu
The following options are available from the PCI Hot Plug Manager menu:
Note: For information about the PCI slot LED states, see “I/O Drawer PCI Slot LED
Definitions” on page 430.
List PCI Hot-Plug Slots
Provides a descriptive list of all slots that support PCI hot-plug capability. If the listing
for a slot indicates it holds an “Unknown” device, select the Install/Configure Devices
Added after IPL to configure the adapter in that slot.
438 Service Guide