RIO Card Assembly
Removal
1. Turn off power as described in “Powering Off the System” on page 429.
2. Place the I/O drawer in the rear service position as described in “Rear Service
Position” on page 467.
3. Remove the two thumbscrews and remove the back cover.
Rear
Cover
4. Disconnect all cables from the card assembly.
5. Remove the screw and remove the retainer bracket from the rear release latch.
6. Pull up on the release latches and carefully pull the card out of the slot.
Latches
Chapter 9. Removal and Replacement Procedures 449
To Next Page
Loading...