Service Processor Error Codes
Attention: Follow the procedure defined in the “Checkpoint and Error Code Index” on
page 165. If you replace FRUs or perform an action and the problem is still not
corrected, go to “MAP 1540: Minimum Configuration” on page 113 unless otherwise
indicated in the tables.
If you replace FRUs and the problem is corrected, go to ″MAP 410: Repair Checkout″
in the
RS/6000 and
Eserver
pSeries Diagnostics Information for Multiple Bus Systems
.
Table 6. Service Processor Error Codes.
Error Code Description Action/
Possible Failing FRU
4066 0001 Scan interface basic assurance tests
detected CEC backplane fault
CEC backplane
Location: U1.1-P1
4066 0003 Scan interface basic assurance tests
detected processor fault
1. Verify loose or defective JTAG
cable or connector.
2. All processors
Location: U1.1-P1-C1
4066 0009 Scan interface basic assurance tests
detected memory fault
All memory
Location:
U1.1-P1-C1
U1.1-P1-M1
U1.1-P1-M2.
Go to “MAP 1540: Minimum
Configuration” on page 113 and run
CEC drawer minimum configuration
to isolate the failing memory
component.
4066 00A0 Scan interface basic assurance tests
detected service processor firmware
fault
Update system firmware
4066 00A1 Scan interface basic assurance tests
detected system firmware fault
1. Check for AIX updates
2. Check for system firmware
update
4066 00A2 Scan interface basic assurance tests
detected service processor firmware
(processor runtime diagnostics) fault
Check for system firmware update
4066 00A3 Scan interface basic assurance tests
detected memory plugging fault
All pluggable memory.
Go to “MAP 1540: Minimum
Configuration” on page 113 and run
CEC drawer minimum configuration
to isolate the failing memory
component.
4066 00A4 Scan interface basic assurance tests
detected application caused fault
Application software
4066 00A5 Scan interface basic assurance tests
detected invalid system configuration
Verify system components are
supported and properly installed
Chapter 5. Error Code to FRU Index
213
To Next Page
Loading...