CEC Backplane
Removal
1. Turn off power as described in “Powering Off the System” on page 429.
2. Place the CEC drawer in the rear service position as described in “Rear Service
Position” on page 467.
3. Disconnect and label all cables from the rear of the assembly.
4. Remove the two thumbscrews and remove the back cover.
Back
Cover
5. Remove the memory riser cards. See “Memory Riser Cards and Memory DIMMs”
on page 441.
6. Remove the processor card. See “Processor Card” on page 443.
7. Remove the screws from the card cage assembly and remove the assembly.
Card
Cage
Assembly
Chapter 9. Removal and Replacement Procedures 445
To Next Page
Loading...