IBM 7026-H80 - RS/6000 - 256 MB RAM - System Firmware Update Messages; Common Firmware Error Codes

Table 6. Service Processor Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
4B2F 303A Processor system and error code
generation/logging detected 1GB
DIMM fault
Memory DIMM
Locations:
U1.1-P1-M1.n
U1.1-P1-M2.n
U1.1-P1-C1-Mn
4B2F 51AA Processor system and error code
generation/logging detected 645W
AC power supply fault
645W AC power supply
Locations:
U1.1-V1
U1.1-V2
4B2F 51AB Processor system and error code
generation/logging detected 645W
DC power supply fault
645W DC power supply
Locations:
U1.1-V1
U1.1-V2
4B2F 51AC Processor system and error code
generation/logging detected 595W
AC power supply fault
595W AC power supply
Locations:
U0.1-V1
U0.1-V2
4B2F 51AD Processor system and error code
generation/logging detected 595W
DC power supply fault
595W DC power supply
Locations:
U0.1-V1
U0.1-V2
System Firmware Update Messages
Table 7. System Firmware Update Messages
Error Code Description Action/
Possible Failing FRU
A1FD 0000 Recovery mode entered Information message
A1FD 0001 Service processor flash recovery Insert Diskette #1
A1FD 0002 Service processor flash recovery Insert Diskette #2
A1FD 0003 Service processor flash recovery Insert Diskette #3
A1FD 0004 Service processor flash recovery Insert Diskette #4
Common Firmware Error Codes
Attention: Follow the procedure defined in “Checkpoint and Error Code Index” on
page 165. If you replace FRUs or perform an action and the problem is still not
corrected, go to “MAP 1540: Minimum Configuration” on page 113 unless otherwise
indicated in the tables.
354 Service Guide