Table 2. Firmware Checkpoints (continued)
Checkpoint Description Action/
Possible Failing FRU
E152 Probing for adapter FCODE,
evaluate if present
Follow the repair action listed for
checkpoint E151.
E153 End adapter FCODE,
probe/evaluate
See the note on page 139.
E154 Create PCI bridge node Follow the repair action listed for
checkpoint E151.
E155 Probing PCI bridge secondary bus Follow the repair action listed for
checkpoint E151.
E156 Create PCI ethernet node Follow the repair action listed for
checkpoint E151.
E15A Create 64-bit host (primary) PCI
controller node
See the note on page 147.
E15B Transferring control to Operating
System (service mode boot)
See “Boot Problems and Concerns”
on page 159.
E15C Probe primary 64-bit PCI bus See the note on page 147.
E15D Create host PCI controller node See the note on page 147.
E15F Adapter VPD probe Follow the repair action listed for
checkpoint E151.
E162 SP node VPD creation See the note on page 147.
E163 Create CPU VPD See the note on page 147.
E165 Create planar-clock VPD See the note on page 147.
E166 Create CEC VPD See the note on page 147.
E167 Collect power cards VPD. See the note on page 147.
E170 Start of PCI Bus Probe Follow the repair action listed for
checkpoint E151.
E172 First pass PCI device probe Follow the repair action listed for
checkpoint E151.
Chapter 4. Checkpoints
149
To Next Page
Loading...