IBM 7026-H80 - RS/6000 - 256 MB RAM - Page 169

Table 2. Firmware Checkpoints (continued)
Checkpoint Description Action/
Possible Failing FRU
E193 Initialize Super I/O See the note on page 139.
E196 Probe ISA bus See the note on page 139.
E199 Reboot after flash Try to boot system a second time.
If this does not work, replace the
primary I/O backplane.
See the note on page 139.
E19B Create service processor node See the note on page 139.
E19C Create tablet node See the note on page 139.
E19D Create NVRAM node See the note on page 139.
E19E Real-time clock (RTC) initialization Refer to error code 28030xxx in
“Firmware Error Codes” on
page 190.
E1AD See description of checkpoint
E1DE
See the note on page 139.
E1B0 Create lpt node See the note on page 139.
E1B1 Create serial node See the note on page 139.
E1B2 Create audio node See the note on page 139.
E1B3 Create 8042 node See the note on page 139.
E1B6 Probe for (ISA) keyboard See the note on page 139.
E1BD Probe for (ISA) mouse See the note on page 139.
E1BF Create pwr-mgmt node See the note on page 139.
E1C4 Build ISA timer chip node See the note on page 139.
E1C5 Create ISA interrupt controller (pic)
node
See the note on page 139.
E1C6 Create DMA node See the note on page 139.
E1D0 Create PCI SCSI node Perform Repair actions from
checkpoint E156.
E1D3 Create SCSI block device node
(SD)
Perform Repair actions from
checkpoint E156.
E1D4 Create SCSI byte device node (ST) Perform Repair actions from
checkpoint E156.
E1DB Create floppy controller (FDC) node Replace the primary I/O backplane.
See the note on page 139.
Chapter 4. Checkpoints
151