IBM 7226 Manual

Step 1
DANGER
An electrical outlet that is not correctly wired could place hazardous voltage on the metal parts of the system or the devices
that attach to the system. It is the responsibility of the customer to ensure that the outlet is correctly wired and grounded to
prevent an electrical shock. (D004)
This step verifies whether the power is operating properly.
1. Make sure that the 7226 storage enclosure power cable is plugged into an electrical outlet.
2. Check the power cable connections at the rear of the 7226 storage enclosure and at the electrical outlet.
3. Press the power switch on the 7226 storage enclosure.
4. Check the state of the power-on LED on the front of the 7226 storage enclosure.
Note: The power-on LED is located on the power switch.
IBM 7226 Model 1U3 Storage Device Enclosure 259

IBM 7226 Specifications

General

Model	IBM 7226
Type	Storage Enclosure
Form Factor	Rack-mountable
Drive Bays	12
Drive Type	Hot-swappable
Interface	SAS
Compatibility	IBM Power Systems
Supported Drives	SAS, SATA
Host Interface	6 Gbps
RAID Levels	0, 5, 6, 10
Power Supply	Redundant