IBM InfoPrint 6700 Series User Manual

192
Chapter 3 P-SERIES SETUP
Notes:
* = Factory Default
1
All three Form Length submenus work in conjunction.
When you change the default in one submenu, the
default values in the other two submenus change
automatically.
2
These menus do not display when the CT, TN5250,
or TN3270 emulation is selected.
3
The factory default value depends on the width of the
printer model.
4. All Form Width submenus work in conjunction. When
you change the default in one submenu, the default
values in the other two submenus change
automatically.
P-SERIES SETUP
(cont. from prev. page)
Text Position
(page 242)
Bottom of Line* Top of Line
Reset Cmd CFG Ld
(page 236)
Disable*
Host Command
(page 224)
Enable* Ignore All Ignore CPI
Form Length
1, 2
(page 220)
Ignore LPI
Power up config Current config Factory config
Form Length
1, 2
(page 220)
101.6 or 152.4 mm*
3
Form Length
1
(page 220)
Form Width
4
(page 221)
41, 66, or 85 characters*
3
0 to 272 characters
00.0 to 609.6 mm
4 or 6 inches*
3
00.0 to 24.0 inches
24 or 36 lines*
3
0 to 144 lines
Form Width
2, 4
(page 221)
104.1, 168.0, or 215.9 mm*
3
00.0 to 345.4 mm
Form Width
2, 4
(page 221)
04.1, 06.6, or 08.5 inches*
3
00.0 to 13.6 inches

IBM InfoPrint 6700 Series Specifications

General

Brand	IBM
Model	InfoPrint 6700 Series
Category	Printer
Language	English