IBM InfoPrint 6700 Series User Manual

328
Chapter 5 Restore The Printer To Operation
ERROR: WRONG
CHECKSUM
Yes/No The printer received the
complete program but the
checksum did not match.
The data may have been
corrupted during download.
Power off the printer for 15 seconds,
then power back on. If the problem
persists, contact your authorized
customer service representative.
ERROR OCCURRED
FLUSHING QUEUES
Yes An interim message displays
while the printer discards
host data it cannot use
because a fault condition
exists. While this message
displays, the asterisk (*)
rotates.
Wait. When the asterisk (*) stops
rotating, a different fault message will
appear; troubleshoot the final
message.
FAN WARNING
Yes The printer detected that the
power supply fan did not
rotate for at least 45 seconds
when it is was supposed to.
NOTE: This is a warning
message and will not halt
printing. When too high of
internal temperature is
detected, based on its
source, the printer will stop
printing and display a PWR
SUPPLY HOT, PRINTER
HOT or PRINT HEAD HOT
message.
1. Verify that the fan rotates when the
printer is first powered up and when
the printer moves media or prints.
2. Call your authorized service
representative.
FILE EXISTS
Enable Overwrite
Yes The printer operator tried to
save a file using the name of
an existing stored file.
Enter the PRINTER CONTROL menu
and enable the Overwrite Files feature
to overwrite the existing file.
FILE SYS FULL
Add Flash
Yes/No Insufficient flash memory
available to store file.
Install a larger flash memory SIMM.
For additional flash, contact your
authorized service representative.
FILE SYS FULL
Delete Files
Yes Insufficient flash memory
available to store file.
Enter the PRINTER CONTROL menu.
Use Delete Files to delete unwanted
files.
FILE SYS FULL
Optimize & Reboot
Yes Insufficient flash memory
available to store file.
Enter the PRINTER CONTROL menu
and use the Optimize & Reboot
feature.
FILE SYS INVALID
Optimize&Reboot
Yes/No File system not detected or
flash was corrupted.
Enter the PRINTER CONTROL menu
and use the Optimize & Reboot
feature.
FILE SYS WRITE
Check Flash
Yes/No Problem writing to flash
memory.
Power off the printer for 15 seconds,
then power back on. If the problem
persists, contact your authorized
customer service representative.
FPGA FILE
NOT FOUND
Yes/No The program file was not
downloaded successfully.
1. Download the program file again.
2. If the message reappears, contact
your authorized customer service
representative.
Table 17. LCD Message Troubleshooting (continued)
Displayed Message
Can User
Correct?
Explanation Solution

IBM InfoPrint 6700 Series Specifications

General

Brand	IBM
Model	InfoPrint 6700 Series
Category	Printer
Language	English