40000011-00000000 Security: Login ID: [arg1] had [arg2] login failures from CLI at [arg3].
Explanation: This message is for the use case where a user has failed to log in to a Management Controller from the
Legacy CLI.
May also be shown as 4000001100000000 or 0x4000001100000000
Severity: Warning
Alert Category: System - Remote Login
Serviceable: No
CIM Information: Prefix: IMM and ID: 0017
SNMP Trap ID: 30
Automatically notify Support: No
User response: Complete the following steps until the problem is solved:
1. Make sure that the correct login ID and password are being used.
2. Have the system administrator reset the login ID or password.
40000012-00000000 Remote access attempt failed. Invalid userid or password received. Userid is [arg1] from WEB
browser at IP address [arg2].
Explanation: This message is for the use case where a remote user has failed to establish a remote control session
from a Web browser session.
May also be shown as 4000001200000000 or 0x4000001200000000
Severity: Info
Alert Category: System - Remote Login
Serviceable: No
CIM Information: Prefix: IMM and ID: 0018
SNMP Trap ID: 30
Automatically notify Support: No
User response: Make sure that the correct login ID and password are being used.
40000013-00000000 Remote access attempt failed. Invalid userid or password received. Userid is [arg1] from
TELNET client at IP address [arg2].
Explanation: This message is for the use case where a user has failed to log in to a Management Controller from a
telnet session.
May also be shown as 4000001300000000 or 0x4000001300000000
Severity: Info
Alert Category: System - Remote Login
Serviceable: No
CIM Information: Prefix: IMM and ID: 0019
SNMP Trap ID: 30
Automatically notify Support: No
User response: Make sure that the correct login ID and password are being used.
40000011-00000000 • 40000013-00000000
342
IBM System x3550 M4 Type 7914: Installation and Service Guide
To Next Page
Loading...
