IBM System x3550 M4 - Page 438

806f0008-0a02xxxx [PowerSupplyElementName] has been added to container [PhysicalPackageElementName].
(Power Supply 2)
Explanation: This message is for the use case when an implementation has detected a Power Supply has been
added.
May also be shown as 806f00080a02xxxx or 0x806f00080a02xxxx
Severity: Info
Alert Category: System - Other
Serviceable: No
CIM Information: Prefix: PLAT and ID: 0084
SNMP Trap ID:
Automatically notify Support: No
User response: No action; information only.
806f0009-1301xxxx [PowerSupplyElementName] has been turned off. (Host Power)
Explanation: This message is for the use case when an implementation has detected a Power Unit that has been
Disabled.
May also be shown as 806f00091301xxxx or 0x806f00091301xxxx
Severity: Info
Alert Category: System - Power Off
Serviceable: No
CIM Information: Prefix: PLAT and ID: 0106
SNMP Trap ID: 23
Automatically notify Support: No
User response: No action; information only.
806f000d-0400xxxx The Drive [StorageVolumeElementName] has been added. (Drive 0)
Explanation: This message is for the use case when an implementation has detected a Drive has been Added.
May also be shown as 806f000d0400xxxx or 0x806f000d0400xxxx
Severity: Info
Alert Category: Critical - Hard Disk drive
Serviceable: No
CIM Information: Prefix: PLAT and ID: 0162
SNMP Trap ID: 5
Automatically notify Support: No
User response: No action; information only.
806f0008-0a02xxxx • 806f000d-0400xxxx
420
IBM System x3550 M4 Type 7914: Installation and Service Guide