IBM System x3550 M4 - Page 443

806f000f-220104xx The System [ComputerSystemElementName]has encountered a motherboard failure. (ABR
Status)
Explanation: This message is for the use case when an implementation has detected that a fatal motherboard failure
in the system.
May also be shown as 806f000f220104xx or 0x806f000f220104xx
Severity: Error
Alert Category: Critical - Other
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0795
SNMP Trap ID: 50
Automatically notify Support: No
User response: This is a UEFI detected event. The UEFI diagnostic code for this event can be found in the logged
IMM message text. Please refer to the UEFI(POST) error code in the "UEFI(POST) error code" section of the Info
Center for the appropriate user response. Firmware Error : Sys Boot Status :
806f000f-220107xx The System [ComputerSystemElementName] encountered firmware error - unrecoverable
keyboard failure. (ABR Status)
Explanation: This message is for the use case when an implementation has detected that System Firmware Error
Unrecoverable Keyboard failure has occurred.
May also be shown as 806f000f220107xx or 0x806f000f220107xx
Severity: Error
Alert Category: Critical - Other
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0764
SNMP Trap ID: 50
Automatically notify Support: No
User response: This is a UEFI detected event. The UEFI(POST) error code for this event can be found in the logged
IMM message text. Please refer to the UEFI(POST) error code in the "UEFI(POST) error code" section of the
Information Center for the appropriate user response. Firmware Error : Sys Boot Status :
806f000f-22010axx The System [ComputerSystemElementName] encountered firmware error - no video device
detected. (ABR Status)
Explanation: This message is for the use case when an implementation has detected that System Firmware Error No
video device detected has occurred.
May also be shown as 806f000f22010axx or 0x806f000f22010axx
Severity: Error
Alert Category: Critical - Other
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0766
SNMP Trap ID: 50
Automatically notify Support: No
User response: This is a UEFI detected event. The UEFI(POST) error for this event can be found in the logged IMM
message text. Please refer to the UEFI(POST) error code in the "UEFI(POST) error code" section of the Information
Center for the appropriate user response. Firmware Error : Sys Boot Status :
806f000f-220104xx • 806f000f-22010axx
Appendix A. Integrated management module II (IMM2) error messages 425