Using Passwords
IBM BIOS Setup Utility
Set Power-On Password
Set Hard Disk1 Password
Set Hard Disk2 Password
Set Supervisor Password
[Enter]
[Enter]
[Enter]
[Enter]
Password Item Specific Help
F1 Help Select Item Space/- Change Value F9 Setup Defaults
F3/ESC Exit Select Menu Enter Select > Sub-Menu F10 Save and Exit
↑↓
↔
Set Power-On Password Selecting this displays a window
for setting the power-on password.
Set Hard Disk1 Password Selecting this displays a window
for setting the hard disk password.
Set Hard Disk2 Password Selecting this displays a window
for setting the second hard disk password (enabled only
when a second hard disk drive is installed in the UltraBay
FX).
Set Supervisor Password Selecting this displays a window
for setting the supervisor password.
4. Select the type of password you want to set, and press Enter.
The "Set Password" window appears.
5. Type your desired password and press Enter.
Note: You can type a maximum of seven random characters
using a combination of letters (
A
to
Z
) and numbers (
0
to
9
). Uppercase and lowercase letters (for example,
A
and
a
) are treated as the same character.
If you type a wrong character, use the Backspace key to
erase it and then type the correct one.
Protecting Your Computer 89