iCarsoft CR Genius - Exiting Diagnostics

31
In most cases the stored frame is the last DTC that occurred. Certain DTCs,
which have a greater impact on vehicle emission, have a higher priority. In these
cases, the top prioritized DTC is the one for which the freeze frame records are
retained. Freeze frame data includes a “snapshot” of critical parameter values at
the time the DTC is set.
Vehicle Information
The option displays the vehicle identification number (VIN), the calibration
identification(CID), and the calibration verification number (CVN), and other
information of the test vehicle.
O2 Monitor Test
This option allows you access and show the Oxygen Monitor Sensor value,
which indicates the car emission status.
On-Board Monitor
This option allows you to view the results of On-Board Monitor tests. The
tests are useful after servicing or after erasing a vehicle’s control module
memory.
Evap System
This item is used to issue the EVAP system test command.
4.7 Exiting Diagnostics
The Diagnostics application remains open as long as there is active
communication with the vehicle. You must exit the diagnostics operation to stop
all communications with the vehicle before closing the Diagnostics application.
NOTE
Damage to the vehicle electronic control module (ECM) may occur if
communication is disrupted. Make sure all connections, such as diagnostic
cable, USB cable and wireless connections, are properly connected at all times
during testing. Exit all tests before disconnecting the test connection or
powering down the tool.
 To exit the Diagnostics application
1. From an active diagnostic screen, tap the Back or ESC functional
button to exit a diagnostic session step-by-step.
2. From the Vehicle Menu screen, tap the Back button on the right
toolbar; or tap the Back button on the navigation bar at the bottom
of the screen.
3. Or tap the Home button on the diagnostics toolbar to exit the
application directly and return to the CR Genius Job Menu.
Once the Diagnostics application is no longer communicating with the
vehicle, it is safe to open other CR Genius applications, or exit the CR Genius
Diagnostic System and return to the Home screen.