iCarsoft CR Genius - Unit

77
setting and view information about the CR Genius system. There are ten system
settings:
 Unit
 Language
 Data Log
 WIFI
 Data & time
 Brightness
 Screen Sleep
 Vehicle Sorted By
 Restore Default User Profiles
 Restore Factory Settings
Figure 10-1 Sample Setting Screen
This section describes the operation procedures for the settings.
10.1 Unit
This option allows you to change the measurement unit for the diagnostic
system.
 To adjust the unit setting
1. Tap the Settings application on the CR Genius Job Menu.
2. Tap the Unit option on the screen, and a pop-up window for unit
selection will pop up.
3. Select the required measurement unit, Metric or Imperial. A check
mark will display on the right of the selected unit.
4. Tap anywhere outside the pop-up window to exit unit settings.
5. Then tap the Back button on the bottom right corner to return to the