43
Figure 5-19 Sample ETC Function Screen 1
5. Read the operator message on the screen, tap OK to proceed to
the next step, and set the learning parameters as required.
Figure 5-20 Sample ETC Function Screen 2
6. Press the [Yes] button to perform the learning process. Until the
application is complete, press [OK] to exit.
5.5 Injector Coding (INJ) Service
When individual injectors are renewed, the injector control module requires
the new configuration values for the injector to perform correctly. Write injector
actual code or rewrite code in the ECU to the injector code of the corresponding
cylinder so as to more accurately control or correct cylinder injection quantity,
After the ECU or injector is replaced, injector code of each cylinder must be
confirmed or re-coded so that the cylinder can better identify injectors to
accurately control fuel injection.
To Next Page
Loading...
