n Initial settings
After resetting the transceiver, set controls and switch-
es as shown in the figure below.
Turn power ON, then check the display. If any of the
followingindicatorsappear,turnthemOFFasfollows:
•Quicktuningstepindicator“Z”:Push[kHz/MHz].
•RITindicator“RIT” :Push[RIT].
•Splitindicator“SPLIT” :Push[SPLIT].
CCW :Max.counterclockwise
4
18
BASIC OPERATION
n When rst applying power (CPU resetting)
Before first applying power, make sure all connections
required for your system are complete by referring to
Chapter 3. Then, reset the transceiver using the follow-
ing procedure.
q Make sure the transceiver power is OFF.
w While pushing [MW 4] and [M-CL 5], push [POWER]
to turn power ON.
•TheinternalCPUisreset.
•ThetransceiverdisplaysitsinitialVFOfrequencieswhen
resetting is complete.
Resetting CLEARS all programmed contents in
memory channels and returns programmed values
in set mode to default values.
To Next Page
Loading...
