Icom IC-910H - FM Mode Operation; VOX Operation

33
5
RECEIVE AND TRANSMIT
n FM mode operation
qPush[M/S•BAND]toselectthedesiredband.
w Push [FM] to select FM mode.
•“FM”indicatorappears.
 •Push[FM]againtoselectrepeateroperationafterFM
modeselection.“DUP–”and“T”indicatorsappear.
 •Push[FM]for1sec.toselectFMnarrowmodeafterFM
modeselection.“FMN”indicatorappears.
e Rotate the tuning dial to set the desired frequency.
r Push [PTT] to transmit.
 •TheMAINbandindicatorlightsred.
t Speak into the microphone at a normal voice level.
 •Settingthe[MICGAIN]controlto10–12o’clockisrec-
ommended.
y Release [PTT] to receive.
Tuning dial
[FM][M/S•BAND][TRANSMIT]
[MIC GAIN]
n VOX operation (for SSB and FM)
The VOX (Voice-operated Transmission) function
switches between transmit and receive with your voice.
This function provides an opportunity to input log en-
tries into your computer, etc., while operating.
qPush[M/S•BAND]toselectthedesiredband.
w Push either [SSB/CW] or [FM] to select phone
mode (USB, LSB or FM).
e Push [VOX] to switch the VOX function ON and
OFF.
 •“VOX”indicatorappearswhiletheVOXfunctionisacti-
vated.
D Adjusting the VOX gain
q Push [SET] then [VOX] to enter the VOX set mode.
w Push [DN Z] or [Y UP] to select the VOX gain item.
 •“GAIn”isdisplayed.
e Rotate the tuning dial to adjust the VOX gain while
speaking into the microphone at a normal voice
level, until the transceiver begins transmitting.
 •Withtoosensitiveasetting,thetransceivermaytrans-
mit with other than your voice, such as noise, receiving
signal, etc.
 •Push[M-CL5]for1sec.toreturntothedefaultvalue.
r Push [VOX] to exit VOX set mode.
D Adjusting the anti-VOX gain
q Push [SET] then [VOX] to enter the VOX set mode.
w Push [DN Z] or [Y UP] to select anti-VOX gain
item.
 •“Anti”isdisplayed.
e Rotate the tuning dial to adjust the anti-VOX gain
while receiving a signal with a suitable audio output
level, to the point where the transceiver does not
transmit with the audio output from the speaker.
 •Push[M-CL5]for1sec.toreturntothedefaultvalue.
r Push [VOX] to exit VOX set mode.
D Adjusting the VOX delay
q Push [SET] then [VOX] to enter the VOX set mode.
w Push [DN Z] or [Y UP] to select the VOX delay
item.
 •“dELAy”isdisplayed.
e Rotate the tuning dial to adjust the VOX delay time
while speaking into the microphone at a normal
speed, to a convenient interval before returning to
receive.
 •Push[M-CL5]for1sec.toreturntothedefaultvalue.
r Push [VOX] to exit VOX set mode.