Icom IC-910H - 10 Set Mode; Set Mode Description

10
55
SET MODE
n Set mode description
Set mode is used for programming infrequent-
ly changed values or conditions of functions. The IC-
910H has a regular set mode and additional 12 inde-
pendent set modes for simple condition changing.
D Set mode operation
q Push [SET] for 1 sec. to enter the general set mode.
w Push [DN Z] or [Y UP] to select the desired item.
e Set the desired condition using the tuning dial.
 •Push[M-CL5]for1sec.toselectadefaultconditionor
value.
r Push [SET] to exit the set mode.
D Independent set mode operation
q Push [SET].
F M
VFO A
VF O A
S E T
F M
S 1 3
5
7
9 20
40
60dB
S
1
3 5
7
9
20
40
60dB
w Push 1 of following switches/keys to enter the inde-
pendent set mode.
[SPCH], [FM], [SSB/CW], [SCAN], [MPW], [COMP],
[VOX], [TRANSMIT], [NR], [RIT], [ATT], [SWP]
S C A N
e Push [DN Z] or [Y UP] to select the desired item.
r Set the desired condition using the tuning dial.
 •Push[M-CL5]for1sec.toselectadefaultconditionor
value.
S C A N
S C A N
t Push the applicable switch, pushed in step w, or
[SET] to exit the set mode.
F M
VFO A
VF O A
F M
S 1 3
5
7
9 20
40
60dB
S
1
3 5
7
9
20
40
60dB
qw ert
Tuning dial
Exit set mode.
Push applicable key
applicable
Independent
set mode
appears.
Select condition.
Push applicable
key or [SET] key.
Push [SET] momentarily.
applicable keys
Select set mode item.
q
Push [SET] for 1 sec. General set mode appears.
wer
Tuning dial
Exit set mode.Select condition.
Push applicable
key or [SET] key.
Select set mode item.
• SET MODE FLOW CHART
applicable