Icom IC-910H - Memory Select Scan; Tone Scan

47
7
SCANS
n Mode select scan
Scans the memory channels, desired operating mode
is programmed, only.
qPush[M/S•BAND]or[SUB]toselectthedesired
frequency band to be scanned.
w Push [V/M 1] to select memory mode.
e Push [SSB/CW] or [FM] to select the desired oper-
ating mode to be scanned.
 •Theoperatingmodecanalsobechangedduringscan.
rPush[SPCH•LOCK]for1sec.
 •“LOCK”indicatorappears.
t Push [SCAN .] to start the mode select scan.
 •“SCAN”indicatorashes.
y Push [SCAN .] to cancel the scan.
wSelect
mode.
qSelect memory
mode.
e appears. rStart.
tStop.
LOCK
MEMO
USB
VF O A
F M
L OCK
S 1 3
5
7
9 20
40
60dB
60dB
S C A N
S
1
3 5
7
9
20
40
Flashes while scanning
n Tone scan
The transceiver can detect a subaudible tone frequen-
cy in a received signal. By monitoring a signal that is
being transmitted on a repeater input frequency, you
can determine the tone frequency required to access
the repeater.
q Set the desired frequency or memory channel to be
checked for a tone frequency.
w Push [FM] to select FM mode.
ePush[TONE]or[CALL•T-SQL]for1sec.toactivate
the subaudible tone.
 •“T”or“T-SQL”indicatorappears.
r Push [SCAN .] for 1 sec. to start the tone scan.
 •“SCAN”indicatorasheswhilescanning.
 •Scanstopswhenasubaudibletoneisdetected.
 •Scanbecomesslowerorquicker,respectivelywhenthe
noise squelch is open or closed.
t Push [SCAN .] for 1 sec. to cancel the scan.
NOTE: The tone scan automatically changes tone
frequency setting to the detected tone frequency.
qSelect FM mode.
wStart.
eStop.
F M
VFO A
60dB
S C A N
S
1
3 5
7
9
20
40
Flashes while scanning
SQ L
T
-