Icom IC-910H - Programming in VFO Mode; Programming in Memory Mode

41
6
MEMORY OPERATION
n Programming in VFO mode
Memory channel programming can be performed ei-
ther in VFO mode or in memory mode.
q Set the desired operating frequency and mode in
VFO mode.
 •Push[V/M1]toselectVFOmode,ifrequired.
 •Tonefrequency,offsetfrequency,etc.,canalsobepro-
grammed.
 •Inputthefrequencyfromthekeypad
Push [F-INP ENT] ⇒ [1] ⇒ [4] ⇒ [4] ⇒ [.] ⇒ [2] ⇒ [6]
⇒ [8] ⇒ [F-INP ENT]
w Push [DN Z] or [Y UP] to select the desired mem-
ory channel to be programmed.
e Push [MW 4] for 1 sec. to program the displayed fre-
quency and operating mode into the memory chan-
nel.
To check the programmed contents, push [V/M 1] to
select memory mode.
F M
VFO A
USB
VFO A
USB
USB
VFO A
VFO A
Select desired memory
channel.
Beep tones sound.
Set desired frequency
and mode.
n Programming in memory
mode
q Push [V/M 1] to select memory mode.
w Push [DN Z] or [Y UP] to select the desired mem-
ory channel to be programmed.
 •Thetuningdialrotationwhilepushing[F-INPENT]also
selects memory channel.
e Set the desired operating frequency and mode in
the memory mode.
 •Tonefrequency,offsetfrequency,etc.,canalsobepro-
grammed.
 •Setthedesiredoperatingfrequencyusingwiththekey-
pad when programming into blank channels. The tuning
dial rotation for frequency setting cannot be performed
when a blank channel is selected.
 •Inputthefrequencyfromthekeypad
Push [F-INP ENT] ⇒ [1] ⇒ [4] ⇒ [4] ⇒ [.] ⇒ [1] ⇒ [6]
⇒ [4] ⇒ [F-INP ENT]
r Push [MW 4] for 1 sec. to program the displayed fre-
quency and operating mode into the memory chan-
nel.
MEMO
F M
MEMO
USB
MEMO
USB
MEMO
USB
Set desired frequency
and mode.
Beep tones sound.
Select desired memory
channel.