Icom IC-910H - Setting the Satellite VFO; Tracking Selection

49
8
SATELLITE OPERATION
n Setting the satellite VFO
q Push [SATELLITE] to enter the satellite mode.
 •“SATL”indicatorwitheither“NOR”or“REV”indicatorap-
pears.
w Push [V/M 1] to toggle satellite VFO and memory
mode.
 •VFOormemorymodeindicatorisdisplayedintheSUB
band (lower area).
e Push [SCAN . M] to enable the downlink frequency
tuning.
 •Uplinkfrequencyindicationdisappears.
 •Rotatethetuningdialtosetthedownlinkfrequencyand
push [SSB/CW] to select the operating mode.
 •Push[SCAN.
M] again after the tuning.
USB
M E MO
L SB
S A T L
RE V
S 1 3
5
7
9 20
40
60dB
60dB
S
1
3 5
7
9
20
40
r Push [SWP 0 S] to enable the uplink frequency
tuning.
 •Downlinkfrequencyindicationdisappears.
 •Push[SWP0S] again after the tuning.
USB
M E MO
L SB
S A T L
RE V
S 1 3
5
7
9 20
40
60dB
60dB
S
1
3 5
7
9
20
40
NOTE: To select the operating mode for the uplink,
push [SUB] to enable the SUB band access.
n Tracking selection
•Push[F-INPENT
NOR ↔ REV
] for 1 sec. to switch be-
tween normal and reverse tracking.
D Normal tracking
Both downlink and uplink frequencies increase or de-
crease in the same step simultaneously by tuning dial
rotation.
[SATELLITE]
[F-INP ENT]
D Reverse tracking
The downlink frequency follows the tuning dial rotation,
however, the uplink frequency changes in the reverse
direction to the tuning dial rotation in the same step.
USB
M
E
MO
L
SB
NOR
S A T L
RE V
S 1 3
5
7
9 20
40
60dB
60dB
S
1
3 5
7
9
20
40
Satellite mode indication
Varies simultaneously