EasyManua.ls Logo

Icom IC-910H - Operating Mode Selection

Icom IC-910H
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
23
4
BASIC OPERATION
D Frequency setting with the keypad
The operating frequency can be directly entered from
the keypad.
q Push [F-INP ENT] to access the keypad frequency
entry.
•Alldigitsoffrequencyindicationdisappear.
w Push numeral keys to enter the desired operating
frequency.
•Theenterednumberisindicatedfromthe100Hzdigit.
e Push [F-INP ENT] to set the frequency.
keypad
[EXAMPLE]
145.3400 MHz
[F-INP ENT] [1] [4] [5] [.] [3] [4] [F-INP]
435.0000 MHz
[F-INP ENT] [4] [3] [5] [.] [F-INP ENT]
439.1200 MHz
[F-INP ENT] [4] [3] [9] [.] [1] [2] [F-INP ENT]
439.1200 MHz to 439.2604 MHz
[F-INP ENT] [.] [2] [6] [0] [4] [F-INP ENT]
Pushing numeral keys to 100 Hz digit without push-
ing [.] also sets the desired operating frequency.
D Operating mode selection
SSB (USB/LSB), CW, CW-N (CW narrow), FM and
FM-N (FM narrow) modes are available in the IC-910H.
Select the desired operation mode as follows.
• Selecting SSB mode
Push [SSB/CW] to select USB mode.
•USBmodeisgenerallyusedforSSBphoneoperation
on the VHF and UHF bands.
•Push[SSB/CW]for1sec.afterUSBmodeselectionto
switch between USB and LSB mode.
• Selecting CW mode
Push [SSB/CW] to select CW mode.
•Push[SSB/CW]for1sec.afterCWmodeselectionto
switch between CW and CW narrow mode.
The optional CW narrow filter, FL-132 or FL-133, is
required for the MAIN or SUB bands, respectively. In
satellite operation, the optional FL-133 is necessary
to operate CW narrow mode in the MAIN (receive)
band. No audio is output until the optional CW nar-
row filter is installed in the CW narrow mode.
• Selecting FM mode
Push [FM] to select FM mode.
•Push[FM]afterFMmodeselectiontoturntherepeater
mode (duplex negative with repeater tone ON) ON and
OFF.
•Push[FM]for1sec.afterFMmodeselectiontoswitch
between FM and FM narrow mode.
When the optional UT-102 voice synthesizer unit
is installed.
The UT-102 announces the selected mode in an elec-
tronically-generated voice when [SSB/CW] or [FM] is
pushed. (pgs. 69, 71)
[FM] [SSB/CW]

Table of Contents

Other manuals for Icom IC-910H

Related product manuals